19
2017-09
Garage sensor light installation method
Garage sensor light installation method. Because of the length problem, many friends do not know how to install the garage sensor light, and even when hoisting, the two lines cannot be fixed, and the third line is not flat. Today, Xiaobian will share with you the installation method of the garage sensor light. .
Garage sensor light installation method
1. First put the suspension wire on the buckle, and install the suspension wire on the three buckles. Note: it cannot be installed backwards.
2. Fix the tension head to the ceiling, try to use a laser level to install the three tension heads on the same straight line, and ensure that the suspension wires are all on the same line, so that the lamps will not be crooked.
3. Insert the buckle of the installed hanging wire into the card position on the back of the garage light, and hoist it to the corresponding position. This position and the position of the tension head on the ceiling should be in the same horizontal position as possible.
4. At least two people need to cooperate with each other to install the 3-meter garage light. Lift the garage light with the buckle and hanging wire installed, and fix the other end of the hanging wire to the tension head. The length of the three hanging wires should be adjusted to the same.
Haosheng Lighting
Get A Free Consultation
with Our Expert
CopyRight © 2022 Zhongshan Haosheng Lighting Co., Ltd. Rights Reserved